![]() ![]() Can contain up to 64 characters.Įnter the number of seconds the printer waits before considering an SMTP operation to have timed out (1 to 999). This address is used as the sender's address of alert e-mail messages sent from this printer. Can contain up to 32 characters.Įnter the system administrator's e-mail address. With a host of innovative network capabilities, users can work efficiently from their desk or on the go. Can contain up to 32 characters.Įnter the password for logging in to the SMTP server. When sending e-mails to an SMTP server, you can enhance the SMTP server security level by connecting to the POP server for authentication.Įnter the user name for logging in to the SMTP server. Press System Settings Interface Settings tab Optional Network. In this case, configure the connection from System Settings. If you use 'WPA2' for the security method of the access point, you cannot configure the connection from Installation Settings. : The POP3 server is used for authentication. In either case, you can perform setup in the wizard format (Settings) or use manual setup in System Settings. : The printer supports NTLM and LOGIN authentication. : The user name and password are not necessary. Select an authentication method from the following: You can also store a file and simultaneously send it by Scan to Folder. To cancel scanning, press the Clear/Stop key. After checking the preview, you can specify whether to send the file or not. SMB is not a hard version specific protocol: if it was, Windows 7 computers wouldnt be able to connect to Server 2012 and higher servers, or join a domain hosted by them. You can use this screen to check how the originals are scanned and the scan settings used for scanning. It clears the counter of each registered user of the machine. ![]() You can back up the machines Address Book and also restore those backup data to the machine using an SD card, Restoring data overwrites Address Book data stored on the machine. Can contain up to 64 characters.Įnter the port number for SMTP (1 to 65535). Server 2012 does default to SMB3, but it can negotiate down to SMB2, or even SMB1 unless the feature has been removed from the server. Backup/Restore: User Custom Settings & Address Book. Click the tab on the network settings page to configure the SMTP settings.Įnter the IP address or host name of the SMTP server.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |